Cleaning Tips - Cleanfix TW Compact Safety, Operations & Maint. Manual

CLEANING TIPS

P -T :
RE EST
Pre-test an area so cleaning
problems will not develop during
cleaning or after the carpet is
cleaned. Not all products can be
safely used on all fibers and
dyes.
1. Mix the cleaner you are
using according to directions
and select an inconspiciuous
area, such as a corner,
behind a chair etc.
2. Place approximately
teaspoon of the
solution on a spot about the
size of a nickel.
solution in with fibers.
Disconnect the power cord from the outlet before working on this unit.
FREEZING TEMPERATURE PRE-CAUTIONS
If it becomes necessary to store or transport the
unit where temperatures could drop below freezing,
32° F, the pump, solution hoses and valve on the
tools must be protected from freezing with a
solution of automotive radiator antifreeze.
1. Mix ½ gallon of water and ½ gallon of
antifreeze in the solution tank. Hook up the
hoses and tools to the extractor.
2. Turn the pump ON and press the valve to let
antifreeze mixture fill the solution line system.
STORAGE OF EXTRACTOR
This extractor should be stored in an upright
position. Objects should not be stored or stacked
on top of unit.
Always store the extractor in a dry, protected area
at temperatures above freezing.
Disconnect vacuum hoses from tank cover (dome) before folding the handle onto the
machine. Failure to do so may cause the cover (dome) to crack which may affect the
performance of the machine or even require the cover (dome) to be replaced.
Safety, Operation and Maintenance Manual for TW Compact; Version 1.0
3. Press a clean white cotton
cloth against the wet spot
and hold it there for about 10
seconds. Examine cloth to
see if
transferred.
4. Examine
carefully to make sure there
is no color change to the
carpet that did not appear on
the cloth.
P -T H
RE REAT
A :
REA
1
mixed
Pre-treat heavily soiled carpet or
areas of concentrated foot traffic
Work
with pre-spotting or pre-spray
chemical.
CAUTION
CAUTION
If a spotter is used, follow label
directions exactly. DO NOT allow
to dry on carpet as it may
damage the carpet permanently.
any dye has
A
the wet spot FTER
After cleaning the carpet when
replacing the furniture, place a
small square of Styrofoam under
the furniture legs to prevent
moisture
S
EAVILY OILED
finish or rusting metal slides.
3. Disconnect solution supply hoses and vacuum
out remaining antifreeze from the solution tank.
4. To prevent damage to unit, allow the extractor
to reach room temperature before using. The
antifreeze MUST be flushed out of the solution
system with clean water, otherwise, the carpet
may be damaged.
This unit should not be stored in vehicles or areas
where extreme heat or cold occurs.
C :
LEANING
from damaging the
7