Javad TRIUMPH-LS Update To User Manual page 10

White buttons explanation
1. Overall Statistics
• Accept/Reject Statistics: It shows A/B in first line and C/D in the second line. A: Number of
Accepted points. B: Number of Rejected points. C: Number of points not validated (if validate
is selected.) D: Number of points rejected because of too many epochs outside the Confi-
dence Guard. Clicking this button clears the statistics.
• RTK Statistics: Goes to a screen which shows Epoch by Epoch statistics during data collec-
tion, or statistics of all epochs for a collected point or before Accept/Reject. This can also be
accessed via the point list by clicking the blue pane of the point list. Clicking the up naviga-
tion button shows the points that are close to this point.
• Recording Statistics: Shows number of points with recorded data.
• Verify Statistics: Number of Step One restarts, number of groups, number of rejected ep-
ochs that fall outside of the confidence guard during Step 2, if Verify with Reset is selected).
2. Point info: Codes/Attributes/Pages
• Attributes: Shows Code attributes. Click it to get to the Code Attribute selection screen.
• Code: Click to select the code for the points.
• Page: Click to select the page.
• Point Description: Shows point description. Click to change.
• Point Name: Shows point name. Click to change.
• Point Symbol: Shows point symbol. Symbols should be imported first as AutoCAD Blocks,
Icons or PNG images.
• Shape Tag: Click to change the shape tag.
3. Audio/Video/Recording/Sounds
• Audio Record: Click it to set the amount of time that microphone opens automatically at the
beginning of each point collection and audio file gets attached to the point.
• GNSS Recording: Click to enable recording raw GNSS data, select recording media, and
type of data (for each point or continuous.)
• Photo Record: Shows the status of photo recording at surveying. Switch status from red
cross to green check mark if photo was shot at survey.
• J-Tip Sound: Click to select sounds for the J-Tip.
4. Setup/Margins
• Azimuth/Bearing: Click to toggle to show angles in Azimuth or Bearing format.
• Base Guard: Click to set the conditions for alarming the base movement and the check box
to activate it.
• Base Ref. Frame: Click to set the Base Reference Frame.
• Coord. System: Shows current coordinate system.
• Signals: Click to select GNSS signals to track.
• Recall Profile: Open Action profiles screen where you can recall profile with different set-
tings
• AntH: Shows current antenna height and type (slant or vertical)
5. Screen, displays, links
• RTK Charts: Shows RTK horizontal and vertical epochs.
• Rotate CCW: Rotate the map counter clockwise by two degrees.
• Rotate CW: Rotate map clockwise by two degrees.
• Map Zoom in: Click to zoom in
• Map Zoom out: Click to zoom out
• Autoscale: Switches Map scale relative to receiver position and distances to current points
• Camera: Activate TLS cameras. Click to switch to front and bottom cameras.