Exmark TURF RANGER TR23KC Operator's Manual page 33

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
6.2.11 Seat Switch Adjustment
6.2.12 Electric Clutch Adjustment
b) Check the gap between the motion override tube and the spacer. This gap
should measure 1/16" (See Figure 10).
c) If adjustment is required, remove clevis pin at foot pedal end and turn yoke
in or out as required to obtain the 1/16" gap.
MOTION CONTROL LINKAGE ADJUSTMENT
a) With operator out of seat, adjust the seat switch to provide a 1/16"
clearance between the switch plunger and the seat frame (See Figure 11).
b) To adjust, loosen the top nut securing the seat switch to the seat rail
weldment. Adjust the bottom nut until the 1/16" between plunger and seat
frame has been obtained. Tighten the top nut. Recheck the measurement
and adjust again if necessary.
c) Check safety interlock system as outlined in 6.1.5.
SEAT SWITCH ADJUSTMENT
a) Stop engine and remove ignition key.
b) Engage parking brake.
c) Place .015-.021 inch feeler gauge through each of the three clutch gap
holes. If gap exceeds this range, tighten the three adjusting nuts (c) until
the proper gap is obtained (See Figure 12). The three clutch gap holes are
located at the "nut side" of the adjusting bolts. The adjusting bolts can be
identified by the springs surrounding each bolt.
www.mymowerparts.com
FIG. 10
FIG. 11
- 28 -