Exmark TURF RANGER TR23KC Operator's Manual page 28

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
No. 3 (Drive Wheel Bearings)
Located Under Engine Deck
No. 6 (Idler Pivots, Mower Deck)
Monthly disassemble belt and
spring and grease under a
"No Load" condition.
6.1.14 Remove engine shrouds and clean cooling fins:
6.1.15 Change fuel filter:
6.1.16 Lubrication of steering yoke pivot:
6.1.17 Check spark plugs.
6.1.18 Change hydraulic system oil or filter:
d) Lubricate all control linkages, pivot points, etc., with engine oil or other
special lubricant weekly or more often when operating in severe conditions.
Service Interval: See Engine Owner's Manual
a) Stop engine and remove ignition key.
b) Remove cooling shrouds from engine and clean cooling fins. Also clean
dust, dirt and oil from external surfaces of engine, which can cause
improper cooling.
c) Make sure cooling shrouds are properly reinstalled. Operating the engine
without cooling shrouds will cause engine damage due to overheating.
Service Interval: As Required
a) A fuel filter is installed in the fuel line between the fuel tank and the engine.
Replace when necessary
Service Interval: Monthly
a) The steering yoke pivot is permanently sealed and should require no additional
lubrication. If there is evidence of seal leakage, replace the seals or bearings
and fill with SAE No. 2 multi-purpose grease or wheel bearing grease.
Service Interval: 160 hrs.
a) Remove spark plugs, check condition and adjust plug gap, or replace with
new plugs. See Engine Owners Manual.
6.1.18.1 Change hydraulic filter:
Service Interval: After first 250 hrs, then yearly thereafter.
a) Stop engine and remove key.
b) Carefully clean area around filter. It is important that no dirt or
contamination enters the hydraulic system.
c) Unscrew filter and remove.
IMPORTANT: Before reinstalling new filter, fill it with Mobil 1 15W-50
and apply a thin coat of oil on the surface of the rubber seal. Turn filter
clockwise until rubber seal contacts the filter adapter, and then tighten
the filter an additional 2/3 to 3/4 turn. Use only Exmark (Part No. 513211)
or Eaton (Part No. 103144) filter elements.
d) Start engine and run several minutes.
www.mymowerparts.com
- 23 -