Exmark TURF RANGER TR23KC Operator's Manual page 31

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
6.2.6 Parking Brake Quadrant Adjustment
6.2.7 Parking Brake Spring Adjustment
c) Release brake lever.
d) The Neutral Centering Device is located on the right-hand underside of the
engine deck. Loosen jam nut (d) from the ball joint which connects the
override assembly (f), to the engine deck anchor mounting (See Figure 6).
e) Start engine. Operator must be in seat to crank engine. Open to full throttle.
f) Adjust neutral centering device length by rotating the neutral centering
device barrel clockwise or counterclockwise until wheels stop turning or no
longer creep. Tighten jam nut.
g) Remove jumper and reconnect electrical connection to parking brake
safety switch.
h) Check safety interlock system as outlined in Section 6.1.5.
IMPORTANT: Keep clear of wheels and other moving parts when making
these adjustments.
NEUTRAL CENTERING DEVICE ADJUSTMENT
a) Loosen the two 5/16 x 18 screws (a), that clamp the brake quadrant to the
engine deck.
b) Pull parking brake lever towards the operator to the brake "on" position (b).
c) Check linkage to ensure that they butt up against the over-centering stop
bolt (c), and retighten the two 5/16-18 screws (See Figure 7).
PARKING BRAKE QUADRANT ADJUSTMENT
a) Check the pin to pin length and adjust to 11 5/8" as required.
b) Check the compression spring length and adjust to 3 1/32" as required
(See Figure 8).
www.mymowerparts.com
FIG. 6
FIG. 7
- 26 -