Advertisement
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components
and materials requiring selective treatment can be removed.
Tool Description
Phillips screwdriver
Phillips screwdriver
Nut spinner screwdriver
Nut spinner screwdriver
Nut spinner screwdriver
Torx screwdriver
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment:
1. Remove the PDU module
1. Using a #2 Phillips screwdriver, loose the screws attaching the PDU module.
2. Slide the PDU module off the chassis.
2. Remove the power entry connectors on the PDU module
1. Using a #2 Phillips screwdriver, remove the three M3 screws attaching the power entry connectors.
2. Remove the three power entry connectors and attaching cable.
3. Repeat for the other PDU module.
3. Remove the PDU PCB
1. Using a #2 Phillips screwdriver, remove the three M5 screws on the top of panel and remove the attaching
cables.
2. Using a #2 Phillips screwdriver, remove the three M3 screws attaching the PCB.
3. Remove the PCB and the attaching cable holder.
4. Repeat for the other PDU module.
4. Remove the fan cage
1. Using a #1 Phillips screwdriver, remove 30 screws attaching the fan cage.
2. Slide the fan cage with four fan boards off the chassis.
5. Remove the fan board
1. Using a #2 Phillips screwdriver, remove six M3 screws attaching the fan board.
2. Remove the fan board off the chassis.
3. Repeat for the other three fan boards.
6. Remove the chassis bracket
1. Using a #2 Phillips screwdriver, remove six M3 screws attaching the chassis bracket.
2. Remove the two connector off the bracket.
3. Remove the 8 cable holders off the bracket.
4. Remove the chassis bracket off the chassis.
5. Remove the fan connector.
6. Repeat for the other bracket.
7. Remove the extension busbar
1. Using a #10 nut spinner screwdriver, remove the 8 nuts attaching the extension busbar.
2. Remove the 4 washers.
3. Remove the extension busbar.
4. Repeat for the other bracket.
MF877-00
Template Revision A
HPE instructions for this template are available at
Tool Size (if
applicable)
#1
#2
5mm
6mm
10mm
M2.5
MF877-01
Page 2
Advertisement
