Volvo TAD1240GE Operator's Manual page 7

Cooling system
Avoid opening the coolant filler cap when the engine is
warm. Steam or hot coolant can squirt out causing
burns.
If the filler cap, coolant lines, taps or so on must be
opened or removed while the motor is warm the filler
cap must be opened slowly and carefully so that pres-
sure is released before the cap is completely removed
and work is started. Note that the coolant can still be
hot and cause burns.
Fuel system
Always protect your hands when searching for leaks.
Streaming pressurized liquids can make their way into
body tissues causing serious injuries. There is a risk
of blood poisoning.
Always cover the generator if it is placed under the
fuel filter. A fuel spill can damage the generator.
Electrical system
Disconnect the power
Before servicing the electrical system the engine
should be stopped and the electrical power switched
off using the main switch/breakers. External power to
the engine heater, battery charger or other equipment
mounted on the engine must be switched off.
Batteries
Batteries contain a very strong corrosive electrolyte.
Protect your eyes, skin and clothing during charging
or other handling of batteries. Always use safety glas-
ses and gloves.
In case of skin contact, wash with soap and large
quantities of water. In case of eye contact rinse im-
mediately with large quantities of water and contact a
doctor as soon as possible.
Electric welding
Remove the positive and negative cables from the
batteries. Next, remove all connections to the genera-
tor.
Always connect the welding clamp to the component
to be welded and as close to the place to be welded
as possible. The clamp must never be attached to the
engine or so that the current can pass through any be-
arings.
When finished welding: Always connect all connec-
tions to the generator before the battery cables are re-
connected.
Safety information
5