Table of Contents
Advertisement
Outdoor Temperature Sensor Installation
1. Loosen the screw by hand using a Phillips
screwdriver indicated in the figure.
2. Remove the cover by lifting it and pulling it
outward.
3. Mount the outdoor sensor onto an exterior
surface of the building with the supplied screws
(2 pcs) by hand using a Phillips screwdriver.
<bottom of case>
• if neccesarry, use anchors(Included
Accessory).
4. There is a through hole to pass wire into the case.
56
Connecting Electricity
5. After leading wire into the case, connect
wire to the terminal by hand using a Phillips
screwdriver.
6. You can use two knobs to relieve stress of wire.
7. Replace the cover.
The hook should be attached to the stopper.
<behaind of case>
8. Tighten the screw by hand using a Phillips
screwdriver indicated in the figure.
Advertisement
Table of Contents
