Pavilion PV199DV Installation Manual page 54

Setting the Outdoor Reset Control Mode
[I:01_HCt]
1. Connect Outdoor Temperature Sensor to
terminal. (Refer to pages 55, 56 for details.)
2. The ON/OFF button is OFF.
The Operation Display must be off.
3. Press the SETTING button.
Select
and then press the ENTER button.
• The "Installer Mode" screen appears.
4. When entering the "Installer Mode", display
will change to
1 sec.
1 sec.
• This function will appear within the first 10
minutes of connecting electrical power and
before pressing the ON/OFF button.
5. When display shows
, press the
navigate
"Installer Mode".
6. Select
press the ENTER button to enter the function.
7. Press the /
parameter value
the ENTER button to save the settings and to
exit the function.
And additional menu items will become
available to adjust.
• The icon
not detected.
54
Connecting Electricity
buttons,
using the /
, or
.
after 1sec.
buttons to
/
1 sec.
, then
1 sec.
(St: Standard)
buttons to change the
, and then press
will flash if the outdoor sensor is
Adjusting Outdoor Reset Control Options
1. The ON/OFF button is OFF.
The Operation Display must be off.
2. Press the
"Installer Mode".
3. Select
then press the ENTER button to enter the
function.
4. Press the
desired system.
Types of Heating System
Type of Heating System
[1:Ft] (Default)
Fin Tube Baseboard
[2:AH]
Air Handler
[3:CI]
Cast Iron Baseboard
[4:Lr]
Low Mass Radiant Floor
in the
[5:rF]
Mass Radiant Floor
[6:rA]
Radiator
[7:CU]
Custom
5. When you are done, press the ENTER button
to save the settings and to exit the function. If
you select
61.
6. To exit the "Installer Mode" or another
function, press the BACK button.
buttons to navigate
/
in the
1 sec.
1 sec.
buttons to navigate into
/
Temperature
Screen
(°F)
Display
LOW HIGH LOW HIGH
120 180 49
140 180 60
100 170 38
80 140 27
80 120 27
120 170 49
100* 180* 38* 82*
* Factory Default.
, refer to page 55, 60-
, and
Temperature
(°C)
82
82
76
60
49
76