Related Manuals for Kargo Master PRO-II KS
Summary of Contents for Kargo Master PRO-II KS
- Page 1 ASSEMBLY INSTRUCTIONS for : PRO-II 11_1.1 Parts: 0111-0 & 0113-0 ® (916) 638-8703 (800) 343-7486 • 11253- G Trade Center Drive • Rancho Cordova, CA 95742 •...
- Page 2 PII-"KS" (1 ea.) (2 ea.) (2 ea.) (4 ea.) 0111-0 & 0113-0 1/2" x 2 1/2" 3/8" x 2 1/4" 3/8" x 2 3/4" 3/8" x 3" Button Head Bolt Hex Bolt Hex Bolt Hex Bolt (8 ea.) 1/2" x 1" Hex Bolt (11 ea.) 1/2"...
- Page 3 Weight carried on an overhead rack will significantly increase the vehicle's tendency to • RATCHET WRENCH WITH overturn. Kargo Master makes no representation or 1/2", 9/16", & 3/4" SOCKETS warranty as to the amount of weight that can be carried •...
- Page 4 _ 11_1.1 GOOP APPLICATION Swaged joint & holes Apply a healthy air tight bead of goop around every swaged joint as shown, to prevent moisture from leaking into and out of the joint. If this is not done properly, the inside surface of the tubes can rust and rusty water can leak out.
- Page 5 _11_1.1 STEP 4 NOTE: All 4 LEGS are identical with the Leg Cup exception of PART 0113-0 (FORD SUPER DUTY), The FRONT legs are bent twice and the REAR legs are bent only once. NOTE: 6" FOR HIGH RISE CAMPER SHELLS, UP TO ABOVE THE CAB , YOU WILL NEED TO PURCHASE SEPARATELY ACCESSORY EXTENDED LEG KIT # :...
- Page 6 _11_1.1 STEP 6 At each end of CROSS BAR start BOLTS & WASHERS Slide BOLTS & WASHERS into SLOTTED BRACKETS on the INSIDE CLAMP PLATES , snug with an open end 3/4" wrench (included in this package) (MOUNTING PLATES WILL VARY) Depending on the make and model of truck.
- Page 7 Tighten up ALL bolts and... THAT'S IT! You're ready to use and enjoy your 3/8" KARGO MASTER TRUCK RACK! ©2011 KARGO MASTER --KS_11_1.1...
- Page 8 HEAVY LOADS EVENLY DISTRIBUTED AND AS LOW AS POSSIBLE. IT IS IMPORTANT TO NOTE THAT THE KARGO MASTER RACK LOAD BEARING CAPACITY OF 1700 LBS. MAY BE GREATER THAN YOUR TRUCK'S GAWR OR GVWR CAPACITY, AND IS PROBABLY GREATER THAN THE WEIGHT THAT CAN BE SAFELY CARRIED OVERHEAD.