Controlling Hyperdecks With External Hardware Panels; Hyperdeck Setup With Atem 1 M/E Advanced Panel - Blackmagicdesign ATEM Mini Installation And Operation Manual

Playback
To play media on your HyperDeck, simply switch the HyperDeck source to the preview output
and select the clip you want to show. Use the transport controls to cue to the preferred point in
your clip. When you switch your HyperDeck to program output, the 'auto roll' feature will
automatically start playback from this point.
If you want to manually trigger the playback, for example holding on a still frame then rolling,
simply disable the respective HyperDeck's auto roll checkbox in the 'HyperDeck' tab in
ATEM software's 'settings' menu.
Recording
To record to a HyperDeck with a formatted disk inserted, simply press the 'record' button in the
HyperDeck palette transport controls. The 'time remaining' indicator in the HyperDeck palette
will let you know the approximate recording time remaining in the SSD.

Controlling HyperDecks with External Hardware Panels

If you are using an external ATEM hardware panel, you can control any connected HyperDecks
using the hardware panel. Once you have connected your HyperDecks to your ATEM Mini as
described in the 'connecting HyperDecks' section, you can use the system control buttons and
LED menu on your panel to set up and control each HyperDeck.

HyperDeck Setup with ATEM 1 M/E Advanced Panel

Once you have connected your HyperDeck to your switcher, as detailed in the 'connecting
HyperDecks' section, use ATEM 1 M/E Advanced Panel's system control and LCD soft buttons
to setup and control your HyperDecks.
To begin, press the system control 'settings' button.
You'll notice that ATEM 1 M/E Advanced Panel displays four setup options along to top of the
LCD screen. These include 'switcher,' 'panel,' 'HyperDecks,' and 'button mapping.'
Each corresponds to a setup menu. Simply press the LCD soft button above 'HyperDecks' to
enter the 'HyperDeck settings' menu.
The HyperDeck settings menu has three pages, which you can select using the 'left' and
'right' arrow buttons in the system control panel, or by pressing the '1,' '2,' and '3' buttons on
your ATEM 1 M/E Advanced Panel's numerical keypad.
HyperDeck Control 109