Blackmagicdesign ATEM Mini Installation And Operation Manual page 106

4 Plug the HDMI output of your HyperDeck into one of the HDMI inputs of your
ATEM Mini.
5 Repeat the process for each HyperDeck you want to connect.
Now all you have to do is tell ATEM Software Control or ATEM hardware panel which input and
IP address each HyperDeck is using. You can do this easily in the HyperDeck tab in
ATEM Software Control switcher settings, or using the system control soft buttons or LCD menu
on an ATEM hardware panel.
TIP If you want to record the output from your ATEM Mini to a HyperDeck, plug your
switcher's HDMI output into the HDMI input of the HyperDeck. Don't forget to route the
program output to the HDMI output.
If your HyperDeck only has an SDI input, for example HyperDeck Studio Mini, you can
convert ATEM Mini's HDMI output to SDI using a Blackmagic HDMI to SDI converter,
such as a Mini Converter HDMI to SDI, or Teranex Mini HDMI to SDI.
HyperDeck Settings
HyperDeck connection settings are located in the 'HyperDeck' tab of the ATEM Software
Control switcher settings. Here you'll see setup options for up to four HyperDecks.
Type in your HyperDeck's IP address in the 'IP Address' box and choosing the source it's
plugged into from the 'input' dropdown menu. Click 'connect' and your HyperDeck is ready
to be controlled.
Status indicators appear above and below each HyperDeck icon to let you know the
connection status. A green tick means your HyperDeck is connected, in remote and
ready to go.
If your HyperDeck is connected and recognized, but does not have its remote button enabled,
you will see an indicator letting you know remote is not active.
If your HyperDeck is not recognized, you will see a 'failed to connect' indicator. If you see this
indicator, check the HyperDeck's Ethernet port is connected to your network and the
IP address is entered correctly.
HyperDeck Control 106