Advertisement
Assembly Instructions
Hydraulic Mount Assembly
Figure 5
Hydraulic Mount Assembly
Refer to Figure 5:
1.
Attach wire guide (#3) to hydraulic mount (#2) with
3/8"-16 x 1 1/4" GR5 carriage bolts (#5) and hex
flange nuts (#6). Tighten hex flange nuts to the
correct torque.
2. Attach hydraulic linkage (#4) to hydraulic mount (#2)
with 1/2" x 1 1/2" usable length clevis pin (#11) and
two 1/2" SAE flat washers (#7A & #7B) as shown.
3. Secure clevis pin with 1/8" x 1" cotter pin (#13). Bend
both legs of cotter pin around clevis pin (#11) to keep
cotter pin from falling out.
4. Attach base end of transport locking cylinder (#14) to
hydraulic mount (#2) with clevis pin (#1) and two 5/8"
SAE flat washer (#8A & #8B) as shown.
5. Secure clevis pin with two 1/8" x 1 1/4" cotter
pins (#10). Bend both legs of each cotter pin around
clevis pin to keep cotter pins from falling out.
6. Attach rod end of transport locking cylinder (#14) to
hydraulic linkage (#4) with 5/8" x 2 3/16" usable
length clevis pin (#12), two 3/4" USS flat washers,
and one 5/8" SAE flat washer (#8C) as shown.
7.
Secure clevis pin with 1/8" x 1" cotter pin (#13). Bend
both legs of cotter pin around clevis pin to keep cotter
pin from falling out.
2/1/19
35480
Attach Hydraulic Mount Assembly
Models AFM4214 & AFM4216 Shown
Attach Hydraulic Mount Assembly
Refer to Figure 6:
1.
Attach hydraulic mount assembly (#2) to toolbar lock-
up plate (#1) with 3/8"-16 x 1 3/4" GR5
bolts (#3), 3/8" flat washers (#5), 3/8" lock
washers (#6), and hex nuts (#4).
2. Tighten hex nuts (#4) to the correct torque.
!
WARNING
To prevent serious injury or death, stay clear of moving parts
and keep others away from moving parts.
3. See warning above. Do not attach warning decal (#7)
until step 4 below. Locate decal (#7) on toolbar
lock-up plate as follows:
•
Models AFM4211, AFM4214, & AFM4216:
Centered decal between mounting holes in the
location shown on.
•
Model AFM4522:
Locate decal just to the left or right of the mounting
holes.
4. Attach decal to toolbar lock-up plate as follows:
a. Clean area where decal is to be placed.
b. Spray soapy water on the surface where decal is
to be placed.
c. Peel backing from decal and press decal firmly
onto the surface.
d. Squeeze out all air bubbles with edge of a credit
card or with a similar type straight edge.
AFM Hydraulic Wing Unlock Assembly Instructions Manual No. 315-731M
Figure 6
35485
3
Advertisement
