Output Signal Specifications; Transfer Rates; Power Requirement (From Pc At I/O Channel; Physical - National Instruments AT-MIO-16D User Manual

Specifications

Output Signal Specifications

Pin 49 (at +5 V)
Output logic–high voltage at I out = -200 µA
Output logic–low voltage at I out = 1.7 mA
Darlington drive current
(R EXT = 750 Ω, V EXT = 1.5 V)

Transfer Rates

Maximum
Typical
Note: The transfer rate depends on both the computer speed and the software speed. The
maximum transfer rate shown previously is the result of running an assembly program,
which continuously writes a constant to an output port, on an 8-MHz PC AT compatible.
The typical transfer rate is the result of running an assembly program, which continuously
reads data from memory and writes to an output port, on an 8-MHz PC AT compatible.

Power Requirement (from PC AT I/O Channel)

Power consumption

Physical

Board dimensions
I/O connector

Operating Environment

Component temperature
Relative humidity

Storage Environment

Temperature
Relative humidity
AT-MIO-16D User Manual
1.0 A typical (fused)
Minimum
2.4 V
0.0 V
-1.0 mA
500 kbytes/sec
300 kbytes/sec
1.6 A typical at +5 VDC
13.3 in. by 3.9 in.
100-pin male, separable into two 50-pin female
ribbon-cable connectors
0° to 70° C
5% to 90% noncondensing
-55° to 150° C
5% to 90% noncondensing
A-6
Appendix A
Maximum
5.0 V
0.45 V
-4.0 mA
© National Instruments Corporation