Salus VS10WRF Full User Manual page 65

Now you have to set different VS10WRF/VS10BRF as a slave thermostat:
1
Hold
+ +
seconds to expand menu.
4
Now thermostat is looking for the
signal from the coordinator...
7
Using and buttons select the KL08RF
number (press PAIR button on the KL08RF to see
its address number). Press
10
2
5 sec.
5 sec.
5 sec.
buttons for 5 Set thermostat as a non-programmable
5
8
Use
thermostat as a group thermostat „SLAVE"
button to confirm.
(choose number 2). Confirm by
Thermostat has been set as a
SLAVE thermostat. You can see "1"
next to temperature on
the display and lack of clock as
a confirmation. Use
buttons and
choose
thermostat will follow MASTER
goup controller.
and confirm by button.
5 sec.
OR
5 sec.
Open the ZigBee network.
or buttons to set
button.
or
- then SLAVE
3
Set your thermostat for underfloor
heating by „ " or „
Confirm by button.
6
Thermostat has caught the signal from the
coordinator. Press button to confirm.
9
Use or buttons to select
the KL08RF zone number and press
button to confirm.
11
5 sec.
OR
5 sec.
Close the ZigBee network.
" buttons.
3
3
65