Making Adjustments And Selections - Panasonic PT-MZ16K Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector

Making adjustments and selections

When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] is set to [OFF], it is
recommended to perform the focus adjustment after 30 minutes or more have elapsed with the focus test pattern
displayed.
For details of [ACTIVE FOCUS OPTIMIZER], refer to the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE
FOCUS OPTIMIZER] (x page 125).
For details of the test pattern, refer to "[TEST PATTERN] menu" (x page 147).
1) Press the <FOCUS> button to roughly adjust the focus of the projected image. (x page 67)
2) Change the setting of the [PROJECTOR SETUP] menu → [PROJECTION METHOD] depending on the
installation mode. (x page 34)
f Refer to "Navigating through the menu" (x page 76) for the operation of the menu screen.
3) Execute the lens calibration.
f Execute the lens calibration when using the projector for the first time after attaching the projection lens.
(x page 69)
4) Select the input by pressing the input selection button on the remote control or the control panel.
f The buttons that can be used on the remote control or the control panel are as follows.
Remote control:
<RGB1/2> button, <DIGITAL LINK> button, <DVI-D> button, <SDI> button, <HDMI> button
Control panel:
<INPUT SELECT> button
f For details of operation for input selection, refer to "Selecting the input signal" (x page 66).
5) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 42)
6) Press the <SHIFT> button to adjust the position of the projected image.
7) If the input signal is the analog RGB signal or the DVI-D/HDMI signal, press the <AUTO SETUP>
button.
8) Press the <ZOOM> button to adjust the image size to match the screen.
9) Press the <FOCUS> button again to adjust the focus.
10) Press the <ZOOM> button again to adjust the zoom to match the projected image size to the screen.
Note
f When the projector is switched on for the first time after purchase, or when initialized by selecting the [PROJECTOR SETUP] menu →
[INITIALIZE] → [FACTORY RESET], the focus adjustment screen is displayed after projection starts, and then the [INITIAL SETTING]
screen is displayed. For details, refer to "When the initial setting screen is displayed" (x page 57).
f When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] is set to [ON], the [ACTIVE FOCUS OPTIMIZER]
function will stop at the point that the focus adjustment, the periphery focus adjustment, or the zoom adjustment is executed.
f When the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS OPTIMIZER] is set to [ON], the [ACTIVE FOCUS OPTIMIZER]
function will stop at the point that the lens calibration is executed.
64 - ENGLISH
2) 3)
5)
1) 9)
4)
7)
1) 6) 8) 9) 10)
6)
8) 10)
2) 3)
4)