Check The Status Of The Tracker; Check Imei Number Of The Tracker - iTrack Long Life GPS108 User Manual

8.12.5. Schedule report
Send the SMS command "schedule+password+space+1h" to the tracker. It will wake up
every one hour and automatically send a location message after it wakes up. (m: minute; h:
hour; d: day). The maximum time interval is set to three digits and not more than 30 days.
After sending this command GPS & GSM modules shut down and the tracker runs in super
lowest power consumption. Calls or messages cannot wake it up. Triggered alarm can
wake up the tracker to work normally but after alarm is canceled the tracker will resume
schedule report mode.
To cancel: After the tracker wakes up, send SMS command "noschedule+password" to
deactivate this function.
8.12.6. Deep sleep by shock + Schedule report
Send the SMS command "sleep+password+space+schedule+space+12h". The tracker
will reply "sleep schedule ok". Then the tracker will wake up and send the SMS "work
notify" message every 12 hours, and the vibration can wake up the tracker too. After the
tracker wakes up it will send the SMS "deep shock".

8.13. Check the status of the tracker

Send the SMS command "check+password" to tracker and it will reply with a status
report giving the remaining battery percentage, GPS signal, GSM signal, GPRS status,
APN, UP, IP and port, etc.
e.g send SMS command "check123456"to the tracker, and the device will send a status
report like this：
Battery: 100%
GPRS: ON/OFF
GPS: OK/NO GPS
GSM Signal: 1-32 (the higher, the better)
APN: cmnet,user,password;
IP: 104.250.138.146:9000/DNS: 04.GPSTrackerXY.com:9000
Shock: ON/OFF

8.14. Check IMEI number of the tracker

Send the SMS command "imei+password" to the tracker. For example, Send SMS
"imei123456" to the tracker and the 15 digit IMEI number will be returned via SMS.
www.itrackgpstrackers.com 15