Alarm Functions - iTrack Long Life GPS108 User Manual

"noquickstop+password" to tracker. It will reply "noquickstop OK", Then the tracker
won't stop the car immediately after "stop" command.
Instead, it will reply "it will be executed after speed less than 20KM/H", and stop the car
when the speed is less than 20KM/H.
8.10.3. Reactivate relay switch and resume fuel supply
Send SMS command "resume+password" to the tracker, it will reply "Resume
engine succeed", it means the relay switch is reactivated and the fuel supply is
resumed.
Note: Tracker must be fully hard wired by a qualified autoelectrician for engine cut-off
feature to work. Please do not attempt to install without any qualifications or knowledge.

8.11. Alarm Functions

8.11.1. Low battery alarm
8.11.1.1. Send the SMS command "lowbattery+password+space+on" and the tracker will
send the SMS "low battery+latitude/longitude" to authorised numbers 2 times in
total at 15-minute intervals when voltage of battery is approximately 3.5V.
This function is activated by default.
8.11.1.2.
To cancel: Send SMS "lowbattery+password+space+off" to deactivate.
8.11.2. Geo-fence Alert
8.11.2.1. Set up a geo-fence for the tracker to restrict its movements within a boundary. The
unit will send an SMS to authorised numbers when it goes in or out of this
boundary.
8.11.2.2. Set up: When the unit stays immobile in a place for 3-10 minutes, the user can
send SMS "stockade+password+space+latitude,longitude;latitude,longitude"to
unit to set the restricted area. In the event of a breach, it will send the SMS
"stockade!+ latitude & longitude" to the authorised numbers.
Attention: The first latitude & longitude is coordinate of the top left corner of the
Geo-fence, while the second latitude & longitude is the coordinate of the bottom
right corner. It will send SMS alarms at 3 minute intervals once the tracker
breaches the boundary.
8.11.2.3. To cancel: Send SMS "nostockade+password" to deactivate this function.
www.itrackgpstrackers.com 10