Toro TXL 2000 Operator's Manual page 44

2. With the bucket installed and angled downward,
lower it into the ground so that the front of the
traction unit lifts off the ground a few centimeters
(inches).
Note:
If you do not have a bucket, raise
the machine and support it using jackstands
rated for the weight of the machine; refer to
Specifications (page
1. Road wheel
2. Gap is 20 mm (0.8 inch).
3. Shut off the engine and remove the key.
4. Verify that the gap between the 2nd road wheel
from the rear and the track is 20 mm (0.8 inch)
as shown in Figure
proceed to Adjusting the Track Tension (page
44)
Adjusting the Track Tension
1. Park the machine on a level surface and engage
the parking brake.
2. Place a 15 x 15 cm (6 x 6 inch) block under the
rear frame of the machine, directly behind the
track being tensioned.
3. With the bucket installed and angled downward,
lower it into the ground so that the front of the
traction unit lifts off the ground a few centimeters
18).
Figure 68
3. Track
68. If adjustment is needed,
(inches) and the machine tips back onto the
block until the track is completely off the ground.
Note:
If you do not have a bucket, raise
the machine and support it using jackstands
rated for the weight of the machine; refer to
Specifications (page
4. Shut off the engine and remove the key.
5. Loosen the 2 bolts and rotate the access cover
open (Figure
1. Bolt
6. Remove the locking bolt, spacer, and nut
70).
g263492
1. Locking bolt
2. Tensioning screw
7. Using a 1/2 inch drive ratchet, turn the tensioning
screw until the gap between the road wheel and
track is 20 mm (0.79 inch) as shown in
68.
Note:
Turning the screw counter-clockwise
tightens the track; turning the screw clockwise
loosens the track.
8. Align the notch in the tension screw to the
nearest locking-bolt hole and secure the screw
with the locking bolt, spacer, and nut
9. Repeat the procedure for the other track if
needed.
44
18).
69).
Figure 69
2. Access cover
Figure 70
3. Spacer
4. Nut
g262055
(Figure
g262056
Figure
(Figure 70.