Toro TXL 2000 Operator's Manual page 13

Loader Arm/Attachment-Tilt Lever
•
To tilt the attachment forward, slowly move the
lever to the right (Figure
•
To tilt the attachment rearward, slowly move the
lever to the left (Figure
•
To lower the loader arms, slowly move the lever
forward (Figure 18).
•
To raise the loader arms, slowly move the lever
rearward (Figure 18).
Figure 18
1. Lower the loader arms.
2. Raise the loader arms.
By moving the lever to an intermediate position (e.g.,
forward and left), you can move the loader arms and
tilt the attachment at the same time.
Loader-Valve Lock
The loader-valve lock secures the loader
arm/attachment-tilt lever so that you cannot push it
forward. This helps to ensure that no one accidentally
lowers the loader arms during maintenance. Secure
the loader valve with the lock, in addition to the
cylinder locks, any time you need to shut off the
machine with the loader arms raised. Refer to
the Cylinder Locks (page
To set the lock, lift up on it so that it clears the hole in
the control panel and swing it to the left, in front of
the loader-arm lever, pushing it down into the locked
position (Figure 19).
18).
18).
3. Tilt the attachment
rearward.
4. Tilt the attachment
forward.
Using
29).
1. Loader arm/attachment-tilt
lever
Joystick Controls
•
To operate a hydraulic attachment in the forward
direction, press the right button
•
To operate a hydraulic attachment in the reverse
direction, press the middle button
•
To stop the hydraulic attachment, press the left
button (Figure
The buttons are pressure-sensitive. The further you
press a button, the faster the hydraulics flow.
g257146
1. Stop hydraulics
2. Reverse-flow hydraulics
3. Forward-flow hydraulics
13
Figure 19
2. Loader-valve lock
(Figure
(Figure
20).
Figure 20
4. Secondary attachment
function (certain
attachments only)
5. Loader arm extension
lever
g300649
20).
20).
g257144