Toro TXL 2000 Operator's Manual page 35

Checking the Engine-Oil Level
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine, remove the key, and allow
the engine to cool.
3. Open the hood.
4. Clean the area around the oil dipstick and oil-fill
cap (Figure 53).
Figure 53
1. Oil-fill cap
5. Check the oil and add additional oil as needed
(Figure 54).
Important:
Do not overfill the crankcase
with oil; if the oil in the crankcase is too high
and you run the engine, you may damage the
engine.
g302251
2. Oil dipstick
6. Close the hood.
Changing the Engine Oil and Filter
1. Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2. Park the machine on a level surface.
3. Raise the loader arms and secure with the
cylinder locks; refer to
Locks (page 29).
4. Engage the parking brake, shut off the engine,
and remove the key.
5. Drain the oil beneath the platform
CAUTION
Components will be hot if the machine
has been running. If you touch hot
components, you may be burned.
Use care to avoid touching hot
components while changing the oil
and/or filter.
35
Figure 54
Installing the Cylinder
(Figure
g264959
55).