Using The Meter; Changing The Battery; Accuracy - Spectrum Technologies Lightscout 3413F Product Manual

Thank you for purchasing a Field Scout
Meter. This manual describes the features and operation of
the meter.

Using the Meter

1. Turn the dial clockwise to the "ON" position.
2. Hold the meter vertical for accurate readings.
3. Turn the meter off after use to conserve battery power.

Changing the Battery

The Field Scout Light Meters use a standard 9V battery. To
change the battery:
1. Remove the two screws on the back of the meter.
2. Lift the back from the bottom of the meter.
3. Remove the old battery from the connector, and snap the
new battery in its place. Set the battery into the front half
of the case.
4. Connect the front and back of the case at the top (by the
sensor).
5. Close the case and tighten the two screws.

Accuracy

The Field Scout Light Meters are accurate to ±5%. Cosine
correction is accurate to ±3% at 45°, and ±7% at 80°.
For customer support, or to place an order,
2
call Spectrum Technologies, Inc. at
(800)248-8873 or (815) 436-4440
between 7:30 am and 5:00 p.m. CST
FAX (815)436-4460
e-mail: info@specmeters.com.
www.specmeters.com
Spectrum Technologies, Inc
12360 S. Industrial Dr. East
Plainfield, IL 60585
TM
3413F Foot-Candle