Mounting - Tripp Lite SmartPro SMX2200XLRT2U Owner's Manual

Mounting (Rack)
Mount your equipment in either a 4-post or 2-post rack or rack enclosure. The user must determine
the fitness of hardware and procedures before mounting. If hardware and procedures are not suit-
able for your application, contact the manufacturer of your rack or rack enclosure. The procedures
described in this manual are for common rack and rack enclosure types and may not be appropriate
for all applications.
4-Post Mounting
All UPS models include hardware required to mount in a 4-post rack. Select models include an
adjustable rackmount shelf kit to provide additional support. If your UPS model does not include
an adjustable rackmount shelf kit, skip steps 1 and 2.
1
Connect the two segments of each shelf
included screws and nuts
loose so that the shelves can be adjusted in the next step.
2 Adjust each shelf to fit your rack, then mount them in
the lowest available space of your rack with the
screws, nuts and washers provided
support ledges should face inward. Tighten the screws
that connect the shelf segments
3
Attach mounting ears
of your equipment
The ears should face forward.
4 Using an assistant if necessary, lift your equipment
and slide it onto the mounting shelves. Attach your
equipment to the rack by using the appropriate
hardware G through its mounting ears and into the
rack rails.
2-Post (Telecom) Mounting
Two-post mounting will require a Tripp Lite 2-Post Rackmount Installation Kit (Model
2POSTRMKITWM, sold separately). For detailed installation procedures, see the 2POSTRMK-
ITWM Owner's Manual.
B . Leave the screws slightly
C . Note that the
.
B
D to the front mounting holes
E using the screws provided
A using the
B
1
2
.
F
3
G
4
3
A
C
E
D
B
F