BERG Meto-SWT Technical Handbook page 28

8.2.2 Standard Automatic Function
Drive the METO-SWT spraying machine to the front of the pipe rails. Press the green
START button. The METO-SWT spraying machine will now operate automatically in the
program selected.
Walk alongside the METO-SWT spraying machine on the path in order to check the
distance that was set.
The METO-SWT spraying machine must stop approximately 1.5 metres in front of the
wall. Adjust this if required according to the instructions given in the previous pages. Make
sure you are properly protected against the chemical agents, and keep a safe distance!
We advise that you carry out the tests using plain water!
◄ Tank 0% ◄◄
8.2.3 Block shape Automatic Function
Only the contiguously entered Sections will be automatically sprayed in sequence!
If there is a Section at "0 paths" in the settings menu, stop the METO-SWT at that
Section and the message "READY" will flash on the screen.
Always check the green/yellow and the " LENGTH OF PATH " fields after an
ALARM!
Translated user manual V3_EN
Shows path length that is set.
Shows actual driving distance and status of
main path at 0 m.
Actual pressure.
Number of litres sprayed. (indication!)
Tank empty message!
Tank 0% ◄
If the tank becomes empty while spraying, the
METO-SWT spray trolley will stop
immediately and [Tank 0%] will scroll on the
display screen as shown here.
Drive the METO-SWT spray trolley back
manually (8.2.5) and fill the tank.
Automatically spray the entire path again or
resume spraying manually from the place
where the tank was empty.
Shows path length that is set.
Shows actual driving distance.
Shows total number of paths in the Section.
Actual pressure.
Number of litres sprayed. (indication!)
SECTION IN PATH:
Shows the actual path in the actual Section.
METO-SWT 7030.XX.XXXX
 28 / 52