Table of Contents
Advertisement
8.2
Controls
Before you can use the METO-SWT spray trolley, you must enter various settings, in
order to spray according to your spray needs.
Turn the METO-SWT spray trolley ON by turning the main switch (7) to the vertical
position, the display will ask for a password, key in 2678, the main menu appears on the
display.
8.2.1
Adjusting
[LENGTH PATH]
Enter the length of the path.
(For safety's sake, take 3 meters shorter than the actual length, this can be changed
later).
Pay attention! If the pad length is entered too long, large damage can occur!
[SPRAYINGSPEED FORWARDS]
Enter forward speed for driving to the rear outside wall, this is often 100% because
spraying is preferably done only on the return.
[SPRAYINGSPEED BACKWARDS]
Enter reverse driving speed for driving back to the main path, this is usually the speed that
is set for the correct level of emission of the spraying fluid.
[SPEED WITHOUT SPRAYING]
Enter the speed for driving when the spraying valves are shut off, this can be 100% if it
gives no harm to the crop.
[PRE-SPRAY TIME AFTER START METO-SWT]
If it is preferred that the METO-SWT unit sprays while driving forwards to the gable, this
setting can be selected so that spraying comes on before moving.
By default, this setting is 0.5 sec, increase this value if the first plants in the path do not
receive enough spray liquid.
Translated user manual V3_EN
METO-SWT 7030.XX.XXXX
24 / 52
Advertisement
Table of Contents
