Advertisement
MULTIMIKE REGISTRATION GUIDE
STANDARD REGISTRATION
SHAREMIKE REGISTRATION (OTHER REGISTERED COMPONENTS IN PLACE)
(Particularly valuable when Multimike is not easily accessible)
Note: Multimike systems do not use MIC 2 status lights.
For users adding a Sharemike or replacing a lost or malfunctioning Sharemike.
1.
Start with the Multimike plugged in and powered on.
2.
If replacing a Sharemike, make sure the malfunctioning Sharemike is powered off.
3.
If there are Flexmikes, other Sharemikes or a Media Connector present, power them
on and wait until each has a solid blue or red light ("Ready").
4.
Power on the new Sharemike. The microphone #1 blue light should start
blinking.
5.
Slide open the Sharemike battery compartment. The registration button is
located below the battery on the left side, marked REG.
6.
Use another registered functional component (existing Flexmike, Sharemike, or
Media Connector) to trigger the registration function in Multimike.
• Using a paperclip with the end straightened out, press and hold the registration
button inside the registered component for 3 seconds. (For the purpose of
these instructions, it is assumed that a Flexmike is the the existing registered
component.)
• The #1 amber light will begin blinking on the Multimike.
• Briefly press the registration button on the Sharemike. The Sharemike's
#1 light will start blinking alternately.
7.
After several seconds, the #1 light on the Multimike will turn solid
and the #1 light on Sharemike will remain blinking, then turn solid.
8.
The registration is complete. You can begin speaking into the new
Sharemike to verify there is audio.
9.
Place system ID number (attached to the Multimike Quickstart
guide) on the new Sharemike.
NOTE: if at any point, the Multimike or Sharemike lights begin
blinking rapidly, that indicates a registration error. Turn the new
Sharemike off and repeat steps 4-9.
Solid light
Power On
(Existing Good Flexmike)
Blinking lights
Power On
Registration
MICROPHONE
POWER
1
2
MIN
MICROPHONE
AUDIO IN
TONE
POWER
1
2
MIN
MAX
MIN
MAX
TREBLE
BASS
USB POWER
5V/0.2A
REGISTER
USB POWER
+
5V/1.5A
AUDIO IN
BAL. AUDIO OUT
AUDIO OUT
Button
Registration
Button
Blinking lights
AUDIO IN
TONE
MAX
MIN
MAX
TREBLE
BASS
Solid lights
Apply to system components to indicate which parts are registered
as a system. Keep registered items together when storing away.
334-0162-02-00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
RETAIN EXTRA LABELS IN THE EVENT A COMPONENT IS REPLACED OR ADDED.
MIC
LINE
AUDIO OUT/DC IN
Registration ID Labels
10101
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
00-01
Advertisement
