STIEBEL ELTRON SN 5 SLi Operation And Installation
STIEBEL ELTRON SN 5 SLi Operation And Installation

STIEBEL ELTRON SN 5 SLi Operation And Installation

Open vented (non-pressurised) small water heater

Advertisement

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SN 5 SLi and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for STIEBEL ELTRON SN 5 SLi

  • Page 2 Installation site SPECIAL INFORMATION ______________________________________________ OPERATION ____17 General information Installation _______________________________________ 15 ______________________________________________ Safety instructions ____ 18 ______________________________________________ Appliance installation __________________________________________18 Other symbols this documentation Water connection ______________________15 1.3 Units of measurement ______________________________________________ _________________________________________15 Power supply Safety ______________________________________________ ______________________________________________ ______18 __________ 15 Commissioning Intended...
  • Page 3 - Never subject the appliance to water ENVIRONMENT AND RECYCLING pressure. INSTALLATION TEMPLATE FOR SN 5 SLI | SN 5 SL GB (INSIDE - The tap outlet has a vent function. Scale build- THESE INSTRUCTIONS) up can block the outlet and subject the appliance to pressure.
  • Page 4 1.1 Safety instructions 1.1.1 Layout of safety instructions The appliance may be used by children aged 8 and older WARNING Injury Here, possible consequences are listed that may and persons with reduced physical, sensory or mental result KEYWORD Type of risk from failure to observe the safety instructions.
  • Page 5: Appliance Description

    - Wall mounting bracket SN 10 SLi | SN 10 SL GB | SN 15 SLi | SN 15 SL 3.3 kW 5. Troubleshooting - Mounting template (located for SN 5 SLi | SN 5 SL GB inside these instructions) TļĒ ù¼ă...
  • Page 6: Installation

    Always install the appliance vertically and near the draw-off GB | SN 15 SLi | SN 15 SL 3.3 kW supplied separately point. or SN 5 SLi | SN 5 SL GB inside these instructions). Drill the holes and insert suitable rawl plugs. ZCŨĜÑ’...
  • Page 7 Secure the wall mounting bracket using suitable screws. The appliance may develop a leak and cease functioning. Hang the appliance on the wall mounting bracket. Material losses Never subject the appliance to water pressure. Never interchange the water connections. Set the flow rate (see tap instructions). Observe the maximum permissible flow rate with a fully opened tap (see chapter "Installation / Specification / Data table").
  • Page 8 10.2 Recommissioning See chapter "Installation / Commissioning / Initial start-up". ĒăăêńńêĒĉêĉÖ 11. Settings 11.1 Setting the temperature limit 10. Commissioning 2 Temperature selector Commissioning may only be carried out by a Placing the limiting ring behind the temperature selector allows qualified WARNING Electrocution contractor in you to limit the setting range of the temperature selector to a accordance with safety regulations.
  • Page 9: Checking The Earth Conductor

    Remove the flanged immersion heater. Carefully tap the Loud boiling noises The appliance is scaled Descale the appliance. inside the appliance. up.  heating element to remove large limescale deposits. Immerse the heating element up to the flange plate in desca- ZCŨĜÑ’...
  • Page 10: Specification

    Temperature controller High limit safety cut-out <Ĝ SN 15 SL 3.3 kW 15. Specification 15.1 Dimensions and connections SN 5 SLi | SN 10 SLi | SN 15 SLi | SN 15 SL 3.3 kW ZCÑZ<ê ZCĜƃZ<ê ZCĜÑZ<ê ZCĜÑZ<ŗĪŗ÷q ZCŨĜƃ...
  • Page 11: Wiring Diagram

    15.2 Wiring diagram ZĤ¼ êÐ |ŒêĒĉ SN 5 SLi | SN 5 SL GB | SN 10 SLi | SN 10 SL GB | SN 15 SLi SN 5 SL GB | SN 10 SL GB 1/N/PE ~ 220 - 240 V ’...
  • Page 12: Extreme Operating And Fault Conditions

    SN 15 SL 3.3 kW 15.5 Extreme operating and fault conditions In the case of faults, a peak temperature of up to 100 °C may briefly occur in the system. 15.3 Heat-up diagram The heat-up period depends on the degree of scaling and residual heat.
  • Page 13: Details On Energy Consumption

    ZĤ¼ êÐ |ŒêĒĉ 15.6 Details on energy consumption Product data complies with EU regulations relating to the Directive on the ecodesign of energy related products (ErP). ZCÑZ<ê ZCÑZ<& ZCĜƃZ<ê ZCĜƃZ<& ZCĜÑZ<ê ZCĜÑZ<ŗĪŗ÷q 221127 221125 222193 222192 222204 222203 Energy conversion efficiency Daily power consumption 2.28 2.28...
  • Page 14 Phases 1/N/PE 1/N/PE 1/N/PE 1/N/PE 1/N/PE 1/N/PE Frequency 50/60 50/60 50/60 50/60 50/60 50/60 Application limits Temperature setting °C approx. 35 – 85 approx. 35 – approx. 35 – approx. 35 – ap prox. 35 – 85 approx. 35 – range Max.
  • Page 15: Environment And Recycling

    ZCŨĜÑ’ Guarantee The warranty conditions of our German companies do not apply to appliances acquired outside of Germany. In countries where our subsidiaries sell our products, it is increasingly the case that warranties can only be issued by those subsidiaries. Such warranties are only granted if the subsidiary has issued its own terms of warranty.
  • Page 16 ’ ZCŨÑ ZCŨĜƃ ZCŨĜÑ ŷŷŷĪńŒê¼ ¼ùé¼ùŒļĒĉĪ Ēă...

This manual is also suitable for:

Sn 5 sl gbSn 10 sliSn 10 sl gbSn 15 sliSn 15 sl 3,3 kw

Table of Contents