Table of Contents
Advertisement
MAINTENANCE ALL MODELS CONTINUED
CHANGING THE
RUBBER DRIVE
Occasionally the Rubber Drive (#1 in Fig.
C) on the back of the Sharpener will need
replacing. This is easily accomplished.
Remove the worn Rubber Tire by cutting it
with a knife.
To replace the Rubber Drive, engage the
starting lever (#2 in Fig. C), place the new tire
in the grove and stretch it over the rim with a
screw driver.
NOTE: On newer models this is one
piece. Order Part No. 1217550.
CARE OF ROLLERS & RETAINERS
The Rollers and Retainers on the
A clean machine will always function
Footplate should be removed and cleaned
better. It is suggested that lint and dirt
regularly. An air hose is ideal for this. All
should be blown out of the machine regu
dirt and lint should be removed.
larly with an air hose.
Do not oil the rollers.
Must seat in
backplate slot.
Cover Plate must be removed from opening
inside of sharpener housing.
REMOVAL OF THE FOLLOWER
When removing or installing the Follower
(#1 at left) be sure it is properly seated in the
Reversing Drive Shaft (#2). When replacing
the Follower Retaining Nut (#3), turn the nut
down until it is tight. Sharpener must be in up
position in order to get to the Follower
through the side opening. A tool is available
to help remove and replace the Follower. If
desired order #2107600.
7
Advertisement
Table of Contents
