Instructions For Anew Pacer - Wolf NEW PACER 100 Series Parts And Service Manual

INSTRUCTIONS FOR ANEW PACER
CAUTION: READ PAGES 2
&
3 BEFORE OPERATING THIS MACHINE.
This Parts and Service Manual has been supplied to enable you to take the best possible care of your
new machine. By carefully following the service instructions contained in this manual, you will be
assured of the best performance with minimum maintenance of your Wolf Pacer. Corrections of major
maintenance problems should be made at the factory or in the field by a qualified, factory-trained main­
tenance representative.
SHARPENER,
SHARPENER HOUSING
CARRYING HANDLE
STARTING
LEVER
" ­
THUMB SCREWS
ELECTRICAL
(TO REMOVE SHARPENER)
CONNECTION
BOX
PRESSERFOOT
KNOB BLADE
LUBRICATOR LIFT HOOK
ADJUST
TENSION BUDON
PRESSERFOOT
(Stone Sharpener)
OPERATING
LEVER
CD
BALANCE
KNIFE
SCREW
SHARPENER HEAD
OPERATING
(Stone Sharpener)
HANDLE
PRESSER FOOT
ON-OFF
SWITCH
When your new Pacer is first put into service,
allow the machine to come to
room tempera­
ture. Before the machine is plugged in make sure
that the Motor rotates freely and the Knife is prop­
erly set, (turn the Rotor Knob at the rear of the
machine - see above). The Knife should not strike
the table when Knob is rotated.
Caution:
The
Knife is factory sharpened and ready to use on a
new machine. Also check to see if the Crosshead
slides freely between the Guide Plates by
unscrewing the two thumb screws (see above) on
the front of the machine and removing the sharp­
ener and turning the Rotor Knob. If the
Crosshead does not slide freely see page 6 for,
Adjustment of the Guides. Note: Do not oil
graphite Crosshead Guides. (Heavy duty steel
require lubrication.