Wolf NEW PACER 100 Series Parts And Service Manual page 5

• • •
THE ELECTRICAL CONNECTOR
The Connector Box on the Pacer is drilled for both
single and three phrase cord coupling (as shown
below). Wolf (as well as many other) plugs will fit
by using smaller pins available from the factory. If
you install connection block pins, be sure that they
are tight, and that the grounding support knob on
the cord is used.
Before placing three phase machines into service
be positive that the motor will rotate in the direc­
tion indicated by the arrow stamped on the rear
head of the motor. To check the direction of
rotation make a flash contact with the switch
turned on. If the rotation is not in the correct
direction, it can be reversed by reversing any two
of the circuit lines.
If the motor is allowed to run in the wrong
direction, the crank will unscrew and damage the
machine. Single phase motors automatically turn
in the proper direction.
Wolf "Pacer" Connection
Block Diagram of Post
Combinations for various
Cord Coupling Plugs.
To assure best perform­
ance, use only Wolf
replacement parts.
() e
""
,/
•
' " ' "
\ , / \ , / \ , /
""
WOLF 1 PHASE
() e
' "
\ , /
•
' " ' "
\ , / \ , /
'0./
""
EASTMAN 1 PHASE
" "
/"
\,./
.... ..1 ,,./ .... /
' "
WOLF 3 PHASE
' "
.
\ , /
'0./
•
""
' "
•
\ , / '0./
""
EASTMAN 3 PHASE
3