Wolf NEW PACER 100 Series Parts And Service Manual page 15

MAII\JTENANCE BELT SHARPENER CONTINUED
PROPER ADJUSTMENT OF SHARPENER
INSTRUCTIONS FOR NEW NON-ADJUSTABLE PRESSURE ARM
PACER XI Models have a new Non-adjustable Belt Pressure Arm which
eliminates adjusting tension of the Emery Belt Pressure Arm. In addi­
tion to replacing the old Pressure Arm (#1323060) the following parts
are also eliminated: 1331000 - 1331500 - Rod
1331700 - 1331800 - Silencer
1334000 - Release Rod Screw
1335000 - Spring
9901729 - Stop Nut
9902003 - Roll Pin
It is important that the Bevel Adjusting Shoulder Bushing (#1328100) notch be to
the inside, outside or back depending on the bevel required.
The small wedge shaped block on the Non-adjustable Arm should be checked when
in the sharpening position (near middle of Blade). It should be .005" (.127mm) .010"
(.254mm) from the Blade or about the thickness of a piece or writing paper.
ADJUSTING BLADE BEVEL TO ADJUST FOLLOWTHESE STEPS:
To select a bevel that is best suited to the 1. Loosen Nut #1212200 and loosen Shoulder
material to be cut, a general rule is to use Screw (#1 below).
the long bevel on medium and hard coarse 2. Use wrench to select bevel setting of cam and
fabrics and a progressively shorter bevel on hold in position while tightening screw.
finer materials. 3. Hold Screw and tighten Nut.
WAVE BLADE
SETIING
MEDIUM BEVEL
~>
• • • . • . • . • .
LONG BEVEL ;• . . • . • . • • . . . . . • • • . • . . .
~
SHORT BEVEL • . • . . • . . • . . • . . • . • . . . • . . . • .
1/16"
17
3/64"
1··• • .
1/32"
1
7 •
1.588mm 1.191mm
.792mm
T
T
T
13