Assembly And Set-Up - Razor Electric Party POP Owner's Manual

HEADLINE

ASSEMBLY AND SET-UP

Attaching the Handlebars
Tool Required: 5 mm Allen Wrench
1
Loosen the bolt from the
collar clamp.
3
With the front wheel pointed
straight ahead and the handlebars
square to the front wheel, tighten
bolt on the clamp as shown with
a 5 mm Allen wrench.
Tighten securely.
Need Help? Visit our website for product support, a list of authorized service centers in the US and customer service contact information at www.razor.com.
Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is
listed at the back of this manual.
2
With a twisting motion, push and
twist to slide the handlebars onto
the fork.
4 4
WARNING:
Check hand grips and end caps
regularly for wear or damage, as
they are designed to aid in gripping
handlebars and to provide some
protection against possible impact.
Replace immediately if worn, torn,
damaged or missing.
WARNING:
Do not attempt to thread the
handlebar into the front fork thread.
Tighten collar clamp securely.
WARNING:
Failure to properly install and tighten
the collar clamp may cause the rider
to lose control and fall. If
you are having difficulty
understanding these instructions,
please contact Razor Customer
Service for assistance.