Before You Begin - Razor Electric Party POP Owner's Manual

BEFORE YOU BEGIN

Remove contents from box. Remove the separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents that may have occurred during shipping. Because your
scooter was assembled and packed at the factory, there should not be any problems, even if the box has a few scars
or dents.
THIS UNIT DOES NOT HAVE A POWER SWITCH. LIGHTS WILL TURN OFF AUTOMATICALLY. UNIT IS
ALWAYS ON STANDBY MODE WHEN NOT BEING RIDDEN.
Estimated Assembly and Set-Up Time
Allow up to 5 minutes for assembly, not including initial charge time.
Allow up to 4 hours for charge (see page 5 for charging information).
Charger
Note: Charger design may
vary from one shown
T-bar
Collar Clamp
Foot-Controlled Power System
Pressure Sensor (under grip tape)
LED Lighted Front Wheel
Required Tool
5 mm
Allen Wrench
2.
1.
Power Cut-Off
and Brake
Charger Port
Hub Motor
LED Lights On and Below Deck
3 3
WARNING: DO NOT USE
NON-RAZOR PRODUCTS WITH
YOUR SCOOTER.
Razor scooters have been built to
certain Razor design specifications.
The original equipment supplied at
the time of sale was selected on
the basis of its compatibility with
the frame, fork and all other parts.
Certain aftermarket products may
not be compatible and will void
the warranty.
Note: Electric scooter must
be moving at least 3 mph (5
km/h) while applying the foot-
controlled power system to
engage motor.
Product ID Locations:
(See locations to the left)
1. Front Left Side of Deck
2. Charger
3. UPC Side of Box (Not Shown)
Box Contents:
• Electric Scooter
• Charger
• Owner's Manual
• 5 mm Allen Wrench