Hoffrichter Point Brief Instructions

CHANGING THE FILTER
Pull out the fi lter on the back of the device and replace
it with a new or cleaned one.
Always use the device with the fi lter element
inserted and clean the fi lter element regularly. If
the fi lter element is heavily soiled or not inserted,
this may damage the device and result in unpleas-
ant odors.
CLEANING
Cleaning the fi lter
1. Pull out the fi lter on the back of the device.
2. Clean the fi lter with mild soapy water (do not use
any other agents), rinse the fi lter thoroughly with
clear water and let the fi lter dry completely.
Cleaning the mask daily
1. Disconnect the mask with the exhalation valve from
the therapy tube.
2. Use mild soapy water for cleaning (do not use any
other agents), rinse thoroughly with clear water
and let the mask dry completely, protected from
direct sunlight.
Cleaning the therapy tube weekly
1. Disconnect the therapy tube from the device and the mask.
2. Use mild soapy water for cleaning, rinse the tube thoroughly with clear water and
let the vertically suspended therapy tube dry completely.
JAB122020
Cleaning the device weekly
1. Unplug the mains plug.
2. Wipe the device with a cloth slightly moistened with soapy water and then rub dry.
Removing the fi lter
Cleaning the headgear
If necessary, the headgear must be cleaned as follows:
1. Remove the headgear from the mask.
2. Clean the headgear in accordance with the information in the headgear manufac-
turer's user's manual.
HOFFRICHTER GmbH · Mettenheimer Straße 12 / 14 · 19061 Schwerin · Germany
phone: +49 385 39925 - 0 · fax: +49 385 39925 - 25 · e-mail: info@hoffrichter.de
web: www.hoffrichter.de · point 2 kurz-eng-030412-01 · art. no.: 5000 0519
1 Therapy tube connection
2 Humidifi er lock
3 Selection keys
4 Enter key
5 Display
6 ON/OFF key
7 Contact socket for humidifi er
(optional equipment variant)
8 Control panel for humidifi er
(optional equipment variant)
9 Rating plate
10 Filter or connection port for
02 0
22
B1
JA
the
fi ltersystempoint 2
11 Air inlet for baro sensor
12 RS232 interface
13 DC power connection
Brief instructions
This document does not replace the manufacturer's user's man-
ual. Follow the user's manual.