Haier HRF-636I 6 Series User Manual page 35

GB
10.9 Electrical connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to the rating plate.
▶ the power socket is earthed and no multi-plug or extension.
▶ the power plug and socket are strictly according.
Connect the plug to a properly installed household socket.
WARNING!
To avoid risks a damaged power cord must be replaced by the customer service (see
warranty card).
10.10 Removing and installing the doors
In the event that you need to remove the appliance doors, please follow the door removal
and installation instructions below (Fig. 10.10).
WARNING!
▶ Before any operation, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶ Block the water supply.
▶ The appliance is heavy. Always handle with at least two persons.
▶ Do not tilt the appliance more than 45° or place it horizontally on the ground
1. Remove the coupler box cover (Fig. 10.10-1)
2. Release the two water couplers as shown in Fig.
10.10-2. Remove the water pipes.
3. Undo the hinge cover screw and remove the cov-
er (Fig. 10.10-3). When removing the freezer door,
disconnect all wires except for the grounding wire.
10- Installation
10.10-1
10.10-2
10.10-3
35