Haier HRF-636I 6 Series User Manual page 33

GB
WARNING!
▶ Only connect to drinking water supply. The water filter only filters impurities in the
water and makes ice clean and hygienic. It cannot sterilize or destroy germs or other
harmful substances.
▶ Too high water pressure in the hose can damage the appliance. Install a pressure
reducer when the water pressure in the hose exceeds 0.6 MPa.
▶ Before connection, check whether the water is clean and clear.
Notice: Water connection
▶ Pressure of the cold water has to be 0.15-0.6 MPa.
▶ The maximum permitted length of water hose is 8 meter. Longer hoses will affect the
ice cubes and cold water content.
▶ Ambient temperature has to be 0 °C minimum.
▶ Keep the water hose away from heat sources.
1. Measure out and cut the length of water pipe re-
quired from the refrigerator to the water supply.
2. Unscrew the metal threaded collar nut at the back
of the appliance and place it over one end of the
water pipe with the anti-syphon valve.
3. Firmly push the water pipe onto the water inlet valve
and tighten up the collar nut.
4. Connect one side of the water pipe to the plastic
adaptor or spherical valve that is installed on the
three-way valve.
5. Fix the other side of water pipe to the anti-syphon
valve.
6. Open the water tap and switch on the appliance to
check if the system is leak free and flush the pipe.
WARNING!
▶ Ensure that the connections are always firm, dry
and leak free!
▶ Make sure the hose is never crushed, kinked, or
twisted
10- Installation
10.5-2
6.35 mm
water pipe with
anti-siphon valve
10.5-1
6.35 mm
10.5-3
10.5-4
water pipe
with anti-
siphon valve
10.5-5
6.35 mm
6.35 mm
33