Haier HRF-636I 6 Series User Manual page 34

10- Installation
10.6
1.
max 45°
3.
10.7
10.7-1
WARNING!
Do not adjust the hinge lifting shaft excessively to a height which might cause the shaft
to leave its original locked position. (Adjustable height range: 3 mm)
10.8
2 h
34
10.6 Aligning the appliance
The appliance should be placed on a flat and solid sur-
face.
1. Tilt the appliance slightly backwards (Fig. 10.6).
2. Set the feet to the desired level.
2.
3. The stability can be checked by alternately bump-
10.7 Fine tuning of the doors
If the doors are still not in one level after levelling the
doors by the feet, this mismatch can be remedied by
turning the hinge lifting shaft at the right bottom cor-
ner of refrigerating door with a spanner (Fig. 10.7)
▶ Clockwise turn lifting shaft with spanner to lower
▶ Antic lock wise turn lifting shaft with spanner to lift
10.7-2
10.8 Waiting time
To the maintenance-free lubrication oil is located in the
capsule of the compressor. This oil can get through
the closed pipe system during slanting transport. Be-
fore connecting the appliance to the power supply you
have to wait at least 2 hours (Fig.10.8) so that the oil
runs back into the capsule.
Make sure the distance to the wall on the hinge
sides is at least 10 cm.
ing on the diagonals. The slightly swaying should
be the same in both directions. Otherwise the
frame can warp; possible leaking door seals are
the result. A low tendency to the rear facilitates
the closing of the doors.
door height (Fig. 10.7-1).
door height (Fig. 10.7-2).
GB