Haier HRF-636I 6 Series User Manual page 17

GB
Notice: Getting ice
▶ Do not take the filled ice container out off the freezer longer than necessary as ice
cubes may melt.
▶ In periods of infrequent ice withdrawal, cubes may stick together. This is normal.
▶ If ice cubes get stale, throw them away and clean the ice container.
▶ 3 seconds after the delivery of ice, the dispenser flap closes with a 'phutt' sound. Don't
remove the glass for 2 to 3 seconds as additional water or ice might be produced.
▶ Crushed ice might be dispensed instead of cubed ice if crushed ice was the last opti-
on selected.
▶ Do not place ice cubes which were not produced by the icemaker into the storage
drawer to prevent damage to the mechanism.
▶ You can switch the setting of the dispenser to Water, Cubed, or Crushed even when
the display is locked.
▶ To prevent the dispension of ice or water when the lever is touched accidentally, the
dispenser does not dispense any ice or water while all lights of the buttons are off.
5.11.1 Getting crushed ice from the dispenser
1. Make sure the Ice Maker function is ON (Fig. 5.11).
2. Place a glass under the water and ice dispenser (Fig. 5.11.1-1) on the front of the ap-
pliance.
3. Press the "Crushed" key to select crushed ice, The "Crushed" icon lights up.
4. Make sure the glass is in line with the dispenser to prevent crushed ice from falling out.
5. Push the glass against the lever. Crushed ice falls into the glass.
WARNING!
▶ Do not use deep, narrow, fragile or delicate glasses or paper cups with the dispenser.
▶ Never place canned drinks or food inside the dispenser, as this will damage the crush-
ing mechanism.
▶ Do not touch the dispenser or remove the cover of the ice maker to avoid accidental
injury or damage to the appliance.
5.12 Cool Water function
With this function the tank in the fridge door is filled au-
tomatically with drinking water which is cooled to drink-
ing temperature and can be tapped.
1. Make sure the water supply valve is opened.
2. Unlock the panel by touching key "G" if it is locked
(Fig. 5.4).
3. Touch key "E" (Water) (Fig. 5.12-1).
4. Indicator "e1" lights up, the function is activated
(Fig. 5.12-2) and water can be tapped.
By repeating the above steps this function can be
switched off again.
5- Use
5.12-2
5.12-1
3 Sec. Filter
3 Sec. Filter
17