IBM 5110 Series Maintenance Analysis Procedures page 187

(~
o
PRINTER MAP
PAGE 3 OF 4
010
(Entry Point C)
-If a PROCESS CH ECK occurs after doing the
following, GO TO MAP 420, Entry Point A.
-Press RESTART. WAIT 25 seconds.
Use the keys on the numeric keyboard.
-Press HOLD
-Hold CMD and press - (minus)
-For BASIC, hold CMD and press *(multiply)
-For APL, hold CMD and press x (multiply)
-Press C
-Press 1
- Press EXECUTE
Do the words TAPE READ DIAGNOSTIC or
DISKETTE READ DIAGNOSTIC appear on the
top line of the display?
Y N
011
Bad F2 (Common and language ROS) card.
012
- Follow the instructions on the display until DSP
MENU appears. THEN:
-Enter 800
- Press EXECUTE
The printer MDI should now load and run.
If a PROCESS CHECK occurs, Go To Map 0420,
Entry Point A.
Follow the instructions on the display.
Return to this step if the M DI directs you to
return to MAP 0810.
Did the MDI run to completion?
Y N
013
Follow the instructions on the display.
o
o
MAP 0810-3
014
Did you disconnect a 5106 and/or a 5114(s)
from the 5110 to run this MDI?
Y N
4
E
015
(Entry Point B)
-Press RESTART. Wait 25 seconds.
Did the customer complain of trouble with
PRINT/PLOT?
Y N
016
No trouble found.
017
-Remove the 5103 tractor assembly.
-Install 1 part paper.
-Set the paper release lever to the rear of the
machine (see 5103 MIM 301).
-Set the copy control dial to 1 (see 5103 MIM
301).
-Insert the PRINT/PLOT tape cartridge or
diskette that IBM supplied to the customer.
For APL, enter:
)LlNK 1
-Press EXECUTE
For BASIC, enter:
LINK 1
- Press EXECUTE
The answers to the questions on the display
are as follows:
1 or 2 Press EXECUTE
1 Press EXECUTE
2 Press EXECUTE
2 Press EXECUTE
When LOADO or CLEAR WS is displayed,
enter the following information:
For APL, enter
(Step 017 continues)
01JAN79
EC 836600 PEC 835541
MAP 0810-3
•