Inserting And Changing The Batteries - VOLTCRAFT LCR-300 Operating Instructions Manual

Do not use any carbon-containing cleaning agents or petrol, alcohol or the like to clean the product.
They will damage the surface of the meter. Furthermore, the fumes are hazardous to your health and
explosive. Also do not use any sharp-edged tools, screwdrivers, metal brushes, etc. for cleaning.
Use a clean, lint-free, antistatic, slightly damp cloth for cleaning the device or the display and the meas-
uring lines. Allow the product to dry completely before you use it again to conduct measurements.

10.3. INSERTING AND CHANGING THE BATTERIES

The multimeter is operated with six micro batteries (type AAA, LR03). You need to insert new, charged
batteries before initial operation or when the battery change symbol appears on the display.
Battery condition good, batteries are fully charged
Battery condition good, batteries are nearly fully charged
Battery condition medium, batteries are nearly empty, they need to be replaced soon
Battery condition bad, batteries are nearly empty, they need to be replaced now
Battery condition insuffi cient, batteries are nearly empty, they need to be replaced at
once.
Proceed as follows to insert or change the batteries:
Disconnect all measuring lines from the meter and switch
it off.
Fold open the setup bracket (5) and loosen the two screws
at the battery compartment.
Push the battery compartment lid with a fi nger as shown.
The lid folds up and can be removed. The batteries can be
accessed now.
Replace the fl at batteries with new one of the same type.
Observe the right polarity as indicated in the battery
compartment.
Close and screw on the battery compartment in reverse
order.
The meter is ready for use once again.
50