Control Elements - VOLTCRAFT LCR-300 Operating Instructions Manual

5. CONTROL ELEMENTS

See fold-out page
1 Display (LCD)
2 Operating button
3 FUNC. button: Switching button for measuring functions
4 CAL button: To perform device calibration for precise measured values
5 Rear battery compartment and folding setup bracket
6 SORTING button: For quick sorting measurements for tolerance determinations
7 Arrow up
8 HOLD button to "freeze" the displayed value
9 D/Q/ESR button: Switching display parameters in L/C measuring operation, arrow to the left
10 SETUP button: To set the reference and tolerance parameters in sorting mode
11 SER/PAL button: To toggle serial and parallel mode, arrow to the right
12 FREQ button: To switch the measuring frequency
13 REL% button: To display the relative deviation in % from a reference value; arrow down
14 Light button to activate and deactivate the display lighting
15 ENTER button: To confi rm the input in sorting mode
16 Lateral mains adapter socket
17 Connection and measuring sockets
18 Plug "OPEN" for insulation of the integrated measuring contacts in measuring line operation
19 Calibration plug "SHORT" for zero calibration
20 Four-conductor measuring terminals with shield (Kelvin measuring lines)
35