Tech Lighting UNILUME 700UCRD Series Installation Instructions page 3

Install the Fixtures
2A
MOUNTING BRACKET
SCREW HOLE
Install the mounting brackets to the fixture by aligning
1
the mounting bracket holes to the screw holes on the
fixture and secure them in place with the mounting
bracket screws.
2B
3
MOUNTING
BRACKET
Carefully plan placement configurations and distances,
2
then place and level the fixture(s) in the predetermined
location(s).
3 Mark points on the mounting surface through the holes
in mounting bracket.
Drill appropriate sized pilot holes at the marked points.
4
MOUNTING BRACKET
SCREW
FIXTURE
3
3
2C 2A
MOUNTING
SCREW
5
Secure the fixture with the provided mounting screws.
5
Connecting the Power Feed Cable
2A 2D
POWER FEED
CONNECTOR
Install the power feed connector by sliding it on to the
6
fixture until it snaps in place.
Install end caps on exposed ends (reversal of section
7
1A).
5