Table of Contents
Advertisement
8
Repeater (if included)
Consoles and Grid Extenders will not be transferred over during the upgrade. However, we offer the Repeater that will extend the range of your Base to sensors.
To add the Repeater follows the steps below:
1)
Remove the back of the Repeater by pressing on the tab and separating the top plate from the bottom plate.
2)
Remove battery tab / Insert the battery.
3)
Verify that the LED light on the front of the Repeater light up. This will verify that the battery has been plugged in correctly.
4)
Snap the back plate back onto the Repeater.
5)
Using the power cord provided plug into the back of the Repeater.
6)
Plug the power cord into a power outlet.
7)
On your Security Touchpad go to Settings
the instructions on the touchpad.
8)
Once the Repeater is added, test the Repeater by opening and closing the sensors near it.
9
Devices
Select the [+] on the top right
For troubleshooting, please visit
On the drop down menu select Repeater
www.lifeshield.com/support-center
Click "ADD" and follow
Advertisement
Table of Contents
