Adjustments And Settings; Using The Printer - Labau TM200 User Manual

Adjustments and Settings

The TM200 Series are set up at the factory to be appropriate for
almost all users. It does, however, offer some settings for users
with special requirements.
It has DIP switches that allow you to change communication
settings, such as handshaking and parity check, as well as print
density.
The TM200 Series also have a near-end sensor for the paper.
This can give you a warning when the paper is almost out. If you
find that there is not enough paper remaining on the roll when the
near-end detector is triggered, you can change the near-end
sensor setting.
See Appendix A if you need to make any of these changes.
1-8

Using the Printer

You can control the basic paper feeding operations of the printer with
the button on the control panel. The indicator lights help you monitor
the printer's status.
Control Panel
Button
The button can be disabled by the ESC c 5 command.
Press the FEED button once to advance paper one line. You can also
hold down the FEED button to feed paper continuously.
Panel lights
POWER
The POWER light is on whenever the printer is on.
ERROR
This indicates an error. See Chapter 4 for information on what to do
when this light comes on.
PAPPER OUT
This light indicates the near end of the paper roll. Install a new paper
roll and the printer will continue printing.
1-9