Installing The Pci Riser; Replacing The Device Cover - Harmonic ProStream X Installation Manual

Result:

Installing the PCI riser

Instructions on how to install the PCI riser.
The PCI riser with the optional card needs to be installed into the device.
1. Grasp the riser assembly with both hands and lower the front end of the riser assembly first, aligning
the riser edge connector with the corresponding riser slot on the server board.
2. Lower the back end of the riser assembly, lining up the tabs on the faceplate with the holes on the
back panel of the chassis.
3. Press down on the riser assembly bracket and faceplate until firmly seated.
CAUTION: Do not rock the riser assembly into place. Doing so may damage the
contact pins within the riser slot.

Replacing the device cover

The device must be operated with the system cover in place to ensure proper cooling.
DANGER: Observe all conventional ESD precautions when handling ProStream devices
and components.
1. Place the system cover onto the chassis and slide forward until the front edge of the system cover is
pressed up against the back edge of the front drive bay.
2. Hand tighten the two captive thumb screws at the back of the chassis.
3. Using a screwdriver, install the top cover screw(s).
29 ProStream X 2.4.x Installation Guide
Installing the PCI riser