Index 1. General information 1. General information Weight Weight Chimney connection withstand the load according to the total weight of the Acrylic glue Fine Fissures Smaller damages Painting crack. Marble/granite Adjustment 2. Before Installing a new replace We recommend to stack the surround without glue in Chimney Draught order to adjust the insert prior to perforating the chimney Air Supply...
All safety distances are minimum distances. Installation of the insert must comply with the rules and regulations of the country where installed. Nordpeis AS Air Supply (FIG Atlanta Air) is not responsible for wrongly assembled inserts.
3. Technical information 5. Assembly Assembly instructions for the insert (FIG 4 - FIG 14) All products Nordpeis have secondary combustion and are clean burning. The combustion takes place in two The following tools are necessary: phases: First the wood burns and then the gases from •...
the height. Dry stack the replace for accurate height 6. Lighting the re for the rst time and positioning of the ue/chimney connection. If a fresh air supply set (accessory) is connected through The insert expands when in use, and for this Take care when inserting logs into the burn chamber, reason the insert must NEVER rest on the in order not to damage the Thermotte plates.
Please also note that the Thermotte™ plates may Warning! release coloured dust when touched. Avoid touching Use replacement parts recommended only by the Manufacturer.
Page 7
9. Advice on lighting a re Choice of fuel All types of wood, such as birch, beech, oak, elm, ash and fruit trees, can be used as fuel in the insert. Wood briquettes and dry kindling wood. Newspapers dense the wood is, the higher the energy value. Beech, cause a lot of ashes and the ink is damaging for the oak and birch has the highest density.
Page 8
Some advice in case of combustion problems Error Explanation Solution The chimney is blocked Contact a chimney sweeper / dealer for more information or clean No draught Downdraught in the room caused by no draught, that the must be installed in the room. Downdraught in the room –...
Page 9
NO Du trenger følgende verktøy Du behöver följande verktyg You need the following tools Tarvitset seuraavia työkaluja 10 mm 13 mm NO: Kappeskive med diamanter SE: Kniv med diamanter GB: Cutting blade with diamonds FI: Timanttiterä 24 mm...
Page 10
FIG 1a - Atlanta / S-26R=mm (253) FIG 1a - Atlanta High / S-26R = mm...
Page 11
FIG 1B Chimney / AIR connection - Altanta - S26R =mm Chimney / AIR connection - Atlanta High / S26R =mm...
Page 12
FIG 2 =Firewall/ Hitzenschutzwand / Mur parfeu / Parete non combustibile / Palomuuri =Combustible material / Brennbarem Material / Matières combustibles/ Parete combustibile / Tulenarka materiaali Atlanta - Atlanta High / S-26R 90 0 45 0 >380 mm >50 mm >1000 mm >1000 mm...
Page 13
FIG 3 Gjellebekkstubben 11, N-3420 Lierskogen, Norway Garantiprogram Karta Gwarancyjna Warranty card Garantijas karte Garanti Garantijos kortel Garantiprogram Garantiileht Takuukortti de garan ie Carte de garantie Garantiekarte Serienummer/Serial number/Serienummer/Sarjanumero/Numéro de série/ Numero di serie/Seriennumer/Numer seryjny/S rijas numurs/ Serijinis numeris/Seerianumber/ / Num r de serie Gyldig kun med kvittering fra forhandler Valid only with receipt from retailer Kun gyldig med kvittering fra forhandleren...
Page 14
FIG 4 FIG 5 ATLANTA: X = 23mm ATLANTA HIGH: X = 24mm FIG 17...
Page 18
Atlanta - Atlanta High / S-26R FIG 16 >405 mm Atlanta - Atlanta High / S-26R FIG 16B 236 mm >75 mm...
Page 19
Atlanta - Atlanta High / S-26R - AIR FIG 17 Atlanta High / S-26R - AIR FIG 17B...
Page 20
Atlanta / S-26R - AIR FIG 17C Atlanta - Atlanta High / S-26R FIG 18 ATLANTA: X = 23mm ATLANTA HIGH: X = 24mm 24 mm...
Page 21
Atlanta - Atlanta High / S-26R FIG 19 Atlanta - Atlanta High / S-26R FIG 20 0 mm...
Page 22
Atlanta - Atlanta High / S-26R FIG 21 Atlanta - Atlanta High / S-26R FIG 22...
Page 23
Atlanta High / S-26R FIG 23 Atlanta High / S-26R FIG 24 10 mm 21-50001-018 - 2x 21-30006-016 - 2x...
Page 24
Atlanta - Atlanta High / S-26R FIG 25 Atlanta - Atlanta High / S-26R FIG 26 21-50001-018 - 1x 21-30004-016 - 1x...
Page 25
Atlanta - Atlanta High / S-26R FIG 27 Atlanta - Atlanta High / S-26R FIG 28 10 mm 21-50001-018 - 2x 21-30004-016 - 2x...
Page 26
Atlanta - Atlanta High / S-26R FIG 29 10 mm 21-50001-018 - 1x 21-30004-016 - 1x Atlanta High / S-26R FIG 30 10 mm 21-50001-018 - 4x 21-30004-016 - 4x...
Page 27
Atlanta / S-26R FIG 30B 10 mm 21-50001-018 - 4x 21-30004-016 - 4x Atlanta / S-26R FIG 31 ≈150...
Page 28
Atlanta High / S-26R FIG 31B ≈150 Atlanta High / S-26R FIG 32 21-50001-018 - 4x 10 mm 21-30004-016 - 4x...
Page 29
Atlanta High / S-26R FIG 33 Atlanta High / S-26R FIG 34 FIG Z...
Page 30
Atlanta High / S-26R FIG 35 Atlanta High / S-26R FIG 36 236 mm...
Page 31
Nordpeis AS Gjellebekkstubben 11 Atlanta-CPR-2014/08/25 EN 13240:2001 / A2:2004 / AC:2007 Atlanta / Atlanta High Heating of living accomodation / Fire safety: Reaction to fire: Distance to combustible: Behind : 50 mm Beside : 380 mm 0,07% vol Emission of combustion...
Need help?
Do you have a question about the Atlanta Series and is the answer not in the manual?
Questions and answers