Unpacking/Installing - KERN MSF 200 Operating Instructions Manual

6 Unpacking/installing

Testing upon
acceptance
Packaging/
Return
Checking the
scale
MSF_200-BA-e-1212
Please check packaging as well as the device on receipt for
possibly visible external damages.
Keep all parts of the original packaging for a possibly required
return.
Only use original packaging for returning.
After the assembly of the height measuring rod, the scale must
be checked using an external measuring rod.
For this put an external, verified measuring rod with the
respective accurateness on the weighing plate or, in case of
wall assembly, vertically on the floor. The height measuring
rod must be shifted in a way that the horizontally unfolded flap
touches the external measuring rod with the lower side at 150
cm.
Information:
The measure of the external measuring rod is not congruent
with the scale of the height measuring rod, it is displaced by
some cm, as the offset between the flap and the reading mark
thus will be considered.
If the measure does not match exactly, loosen again slightly
and shift a little the screws used for assembly and then check
again the measure of 150 cm.
9