Advertisement
Available languages
Available languages
Overview of the Components
15.
PROJECTION button
16.
ON/OFF button
17.
FM/USB button
18.
TIME/SET/M+ button
19.
SNOOZE/ SLEEP/
DISPLAY HIGH/LOW/OFF
PAUSE/PLAY button
20.
HOUR/TU- /PREV button
21.
MIN/TU+/NEXT button
22.
AL1/VOL- button
23.
AL2/VOL+ button
24.
PROJECTION RING (for angle adjustment)
25.
PROJECTOR
26.
LED display
27.
USB playback port
28.
USB-OUT CHARGE charging socket
Back side
15. Battery compartment (power reserve)
16. DC 5V power supply connection
17. Focus control
18. Speaker
19. Dipole antenna
First Use of the Device /Introduction
•
Select a proper place for the device. A dry, level and slip proof surface is suitable.
•
Make sure the device is vented sufficiently!
•
In all modes, the display automatically switches to the time display after about 10 seconds.
Power supply
4.
Make sure the grid voltage corresponds to the figures on the rating plate.
5.
Plug the power supply unit into a properly installed protective contact socket.
Connect the device with the power supply unit by plugging the jack of the power supply unit into the "DC 5V" jack.
6.
Caution:
•
This device should only be used with the mains supply unit (included). Do not use it for other devices.
•
Only use a 5V power supply unit (
Note
•
Disconnect from mains power supply during longer periods of non-use.
•
If you did not insert another reserve battery, the time and the station memory will be lost as soon as the
power supply is interrupted.
•
Inserting the reserve batteries
(Batteries are not included in the scope of delivery)
In case of power failure or if the power supply unit is pulled from the plug, the settings are maintained if the reserve
batteries are inserted.
5. Open the battery compartment on the bottom side.
6. Insert two type AAA/R031.5Vbatteries. Check that the polarity is correct (see battery compartment).
7. Close the battery compartment.
Warning:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of explosion!
CAUTION:
•
Batteries can leak battery acid. If the device is out of use for a long period of time, remove the batteries.
•
Different battery types or new and used batteries must not be used together.
•
Batteries are not to be disposed of together with domestic wastes. Dispose of the used batteries at the
relevant collection bin or at your dealer's.
USB-OUT CHARGE Charging Socket
You can charge your Smart phone through this jack. Use the USB cable of your Smart phone for the connection.
Note:
•
Due to the different Smart phone types that are offered today, and their different charging capacities, the
loading duration is dependent on the Smart phone used and its operating condition.
•
A playback of audio-files through this connector is not possible.
). A different supply unit may damage the device.
USB playback port
This device has been developed in line with the latest technical advances in the USB field. The wide range of different
USB storage devices of all types which are currently on the market, unfortunately do not allow us to guarantee full
compatibility with all USB storage devices. For this reason, in rare cases there may be problems in playing back files
from USB storage devices. This is not a malfunction of the device.
General Operation
Switch device on/off
•
You can toggle the device between standby and radio mode with the ON/OFF button.
•
To disconnect the unit completely from the mains, pull the mains plug from the socket.
Volume
By pressing the AL1/VOL− / AL2/VOL+ buttons you can adjust the desired volume.
FM/USB button
Press the FM/USB button until the desired operating mode is shown on the display.
Display Brightness
In time display mode, use the DISPLAY/HIGH/LOW/OFF button to adjust the display brightness. Select from: Light,
dark and off.
Setting the time (in standby)
3. Keep the TIME/SET/M+ button pressed for a short time. The time indicator begins to flash.
4. Set the hours with the HOUR/TU– button and the minutes with the MIN/TU+ button.
NOTE:
If you do not press a button within 4 seconds, the settings are automatically accepted.
SNOOZE/SLEEP button (Delayed switch-off)
When the device is switched on, you can set the time after which the device will turn into standby mode; set the time in
10 minutes' intervals from 90 to 10 minutes. The device will turn off automatically after the preset time.
Press the SNOOZE/SLEEP button for 2 seconds. The notification "90" will appear in the display.
3.
Press the button repeatedly to reduce the time in steps of 10. The "OFF" setting
deactivates the
4.
function.
NOTE:
•
To call up the still remaining time, press the button briefly.
•
When activated the dot in the display next to "SLEEP" is illuminated.
Radio Mode
Fully uncoil the wire antenna.
4.
Press FM/USB
button. A dot lights up on the display next to FM (frequency modulation)
5.
Search for radio stations:
6.
Briefly press the MIN/TU+ / HOUR/TU– buttons, until you have found the radio station which you are looking for.
Preset station: Keep the TIME SET/M+ button pressed for approx. 3 seconds. Select a preset location with the
buttons MIN/TU+ / HOUR/TU–. Preset the TIME SET/M+ button one more. The station is preset.
NOTE:
•
If the reception is too weak and there is interference on the received station, try to improve the reception by
altering the position and uncoiling or coiling the antenna.
Select the preset radio station
While in radio operation, repeatedly press the TIME/SET/M+ button or press the buttons MIN/TU+ / HOUR/TU-. One
preset location after the other will be called up.
Projection
You can use this unit to project the time onto a wall or the ceiling.
•
You can switch this function on and off with the PROJECTION button
•
Swivel the PROJECTOR to the desired position.
•
The back side of the projector has the FOCUS setting wheel with which you can adjust the sharpness of the
projection.
USB Playback Mode
Press FM/USB
button. Select USB function and "USB" will appear on the LED display.
6.
7.
Insert USB into USB playback port and music will begin to play.
8.
Press the PREV button to backward to last song.
9.
Press the NEXT button to forward to next song.
10. Press PAUSE button to pause the song.
Advertisement
