Installation - BOXLIGHT MimioDisplay 3 Installation & User Manual

Installation

A Professional AV Installer must install the Interactive Touchscreen, failure to do so risks damaging the device
and harming yourself and others. It will also affect your warranty if you cannot prove the installation was
completed by an approved installer.
It is your responsibility to ensure that the wall can bear the weight of the Interactive Touchscreen, Wall
Mount and any additional force that may applied.
Step 1 – Unpack the Interactive Touchscreen by removing clips around the bottom of the carton, lift the top
and leave the base with the display (requires two people). Be warned that the screen can be unstable
and should be held throughout.
If using a mobile stand or another wall-mount then follow those instructions for steps 2 and 5.
Step 2 – fix the mount base plate to wall.
A level is required to ensure the base plate is square and you will need appropriate tools to avoid
drilling into pipes and wires. Boxlight Group does not provide the screws/bolts to fix the base plate
into wall, nor does it recommend the number or type of screws/bolts that should be used. The bolts
that are included are to attach the mount's blades to the VESA mount holes in the back of the
Interactive Touchscreen, adjust according to the desired height.
The interactive touchscreen requires ventilation requires at least 100mm space to left, right and
below, and 300mm space above the display.
Step 3a – fix the mount blades to the VESA mount points at the rear of the Interactive Touchscreen.
Step 3b – fix a NUC mount to the NUC VESA mount points. Insert an OPS into slot after removing the
protective cap. (both not included).
MimioDisplay 3 Installation and User Guide
Installation
9