Contec BUF-PCI(PC) User Manual page 41

Procedure for Use under Windows 95 Version 4.00.950 or
4.00.950a :
(1) Turn the personal computer ON to start up Windows 95.
(2) Windows 95 will come up with the [New Hardware] detection
dialog box. Select [Multimedia Device: Select which driver you
want to install for your new hardware.] and then [Driver from disk
provided by hardware manufacturer].
(3) In the [Install From Disk] dialog box, insert BUF-PCI Driver
Install Disk 1 into the disk drive, enter the drive name: \Win95 in
the [Copy Distributed File From] field, then click on [OK]. This
completes installation of the BUS-PCI(PCI) board.
The "Checking resources" part of this section explains you how to
do it.
Procedure for Use under Windows 95 Version 4.00.950B or
4.00.950C :
(1) Turn the personal computer on to start up Windows 95.
(2) Windows 95 will come up with the [New Hardware] detection
dialog box. In the [Device Driver Wizard] that appears next,
check that "CONTEC Co., Ltd. - Multimedia Device" has been
listed, then select [Next>].
(3) In the next dialog box, select [Specify Location...].
(4) Insert BUF-PCI Driver Install Disk 1 into the disk drive, enter the
drive name: \Win95 in the [Location] field, then click on [OK].
(5) In the next dialog box, check the "Updated driver found for this
device" message, then select [End]. This completes installation of
the BUS-PCI(PCI) board.
After finishing installing the board, confirm the assigned resources.
The "Checking resources" part of this section explains you how to
do it.
BUF-PCI(PC), BUF-PCI(98)
Setup
33